1" & 1-1/2" Bore Gantry Dual Slide
Stop Collars With Rubber Bumpers |
|
|
|
|
| Bore Size |
 A |
Ø B |
C |
|
| Ø1.00" |
 .59 |
Ø 1.13 |
1.09 |
|
| Ø1.50" |
.69 |
Ø 1.75 |
1.21 |
|
Clamping Stop Collars come with rubber bumpers.
When ordering Stop Collars on the front or rear of the axis, the fully retracted, or fully extended gap (Dimension "C") is increased as shown.
On the gantry axis, this will affect the width between the end plates, but the total amount of usable stroke will be unchanged.
|
| Bore Size |
A*** |
Ø B |
C |
|
| Ø1.00" |
1.06 |
Ø 1.13 |
1.09 |
|
| Ø1.50" |
1.19 |
Ø 1.75 |
1.21 |
|
Threaded Fine-Adjust Stop Collars also come with rubber bumpers, and are available on either axis.
Simply slide the body of the collar in place and clamp like standard shaft collars.
Then rotate the knurled portion of the collar for up to .25" of fine stroke adjustment, and lock it in place.
When ordering Threaded Stop Collars on the front or rear of the axis, the fully retracted, or fully extended gap (Dimension "C") is increased as shown.
On the gantry axis, this will affect the width between the end plates, but the total amount of usable stroke will be unchanged.
* Gap when fully retracted
** Gap when fully extended
*** Minimum length of threaded collar in its fully closed position.
Dual Slides |
Gantry Dual Slides |
Single Action Slides
Accessories |
Downloads |
Contact
|
